AOYI stabilizer automatic 220v ac scr DPC-3-M voltage regulator protector

△  Automatic full power output after power on(rapid heating).

1.Working voltage: 150-250VAC 50Hz

2.Load max power: 800W

3.Output power stability: ±1.5%

4.Set power ratio range: 0-99%(1% accuracy)

5.Full power output time setting: 0-99min(1 min accuracy)

6.Opening size dimension: 46*45mm

7.Overall dimension(w*l*h): 52*52*92mm

8.Weight: 200g

Note: 1.S1 switch is full power external manual control switch,when S1 closed,the machine will be full power output.

           2.S1 switch can be controlled by time relay.

           3.S1 switch is not connected will not affect the normal operation.

Example:setting preheating time 5 minutes after machine start,output 60% power

1.Connecting proper according to diagram,check and ensure circuit correct.

2.Electrify DPC and check the panel display

3.Display "XX",press "∧" or "∨" ,set 60,DPC will autosave.

4.Long press(more than 3 seconds) key"SET",display flicker between HP and XX,press "∧" or "∨",set preheating time 05(unit:minute),press "SET" again,DPC will autosave and enter full power output state,then break the power.

5.DPC will enter preheating state(display HP) automatically after electrifying,when preheating finished and display numbers will enter into ratio power output state.

6.If temporary the machine don't need to work,just press key "SET" and adjust to OF (no power output) state will be fine.

7.If full power heating temporary needed during working,just close external manual full power switch S1.