Welcome to wziep.com!
Categories
Welcome to wziep.com!
category： Battery Testers
reference price：￥$250.00 - $270.00
Available for more than 95% laptop battery in the market by the connectors below
Summary
RFNT2 is a battery testing device with two channels, having the features below:
1. Supporting two intelligent batteries at once
2. With charge and test functions
3. LCD for displaying battery information
4. LED for indicating working status
5. Pre-charge, fast charge and constant voltage charge for charging stages
6. With a USB port for connecting with computers, master machine can monitoring and control slave machine
Basic Parameters
Dimensions: 201 x 99 x 35 mm
Weight: 333g
Adapter Input: AC 100 ~ 240 V Output: DC 19V 4.74A
Display mode
Segment LCD with white backlight + LED in red and green
Charging mode
Constant current + constant voltage
Charging current
Maximum charging current of each channel: 2.5A
Standby power consumption≤1W
Working temperature
0~40°C 20%-90% RH (Non condensation)
Storage temperature
-20°C~65°C 10%-95% RH (Non condensation)
Maximum charging time: 8 hours
Function Introduction
Charge
Two channels can work independently and serve two intelligent batteries separately. Active, pre-charge, constant current and constant voltage are the stages of charging mode. The initial charging mode depends on the battery voltage, so active and pre-charge don't happen to every batteries.
Test
Testing time is 30seconds and the purpose is to check both the charging and discharging performances. After finishing test, LED flickers with green color and LCD reports the test result.
Normal: Test OK Shown on LCD
Abnormal: Test NG Shown on LCD
Possible causes and solutions for the abnormal:
1) Cause: battery voltage is too low to discharge
Solution: try to charge the battery to raise voltage
2) Cause: remaining capacity is too full to charge any more
Solution: try to discharge the battery to reduce the remaining capacity
3) Bad contact of battery connecting wires
4) Damaged battery
5) Tester trouble
Online Functions
Tester can be connected with master machine via a USB port. Users can monitor, control and set parameters via Battery Manager software in the master machine.
Monitoring
Battery information can be monitored via three windows.
1. Home screen
Battery bar and brief information can be read on home screen.
2. Battery detail information window
Show smart battery data in real time and the data can be saved and printed in image format.
3. Battery graph window
Voltage, current and capacity are traced in curves.
Control
Battery Manager can control slave machine completely. Right-click menu on the battery bar includes the related commands.
Parameters
Users can set working parameters via set parameter window in Battery Manager.
Others
1. Active cooling
2. Active batteries of zero voltage
When a battery is deep discharged, the discharge protection circuit will start up and the voltage in the battery connector will become zero voltage. In this case, an appropriate voltage should be supplied to active the battery.
3. Battery identification
Battery information can be read from battery management chip after establishing communication.
4. Intelligent protection
Against over-current, over-voltage, over-charge, over-heat and short circuit.
5. Suitable for almost all laptop batteries, above 95%
Accessories
1).1 x adapter
2). 1 x USB cord
3). 1 x CD
4). 13 x connectors
5). 10 x cables
6). 10 x jumpers
