Welcome to wziep.com!
Welcome to wziep.com!
category: Battery Testers
reference price:¥$900.00 - $1,200.00
DC Dummy Load Discharger 24V Battery Tester 100A
1.DC Dummy Load Discharger 24V Battery Tester 100A Introduction
This DC battry/UPS discharger tester was designed as the function of batteries and DC power supply maintenance.
It widely used in broadcasting, communication, electric power electron, scientific research, and so on. The advantages of the product are small volume, light weight, digital display, easy to operate, high intelligence and long life time. After all
parameter setting it can be automatically discharge with constant current.
2.DC Dummy Load Discharger 24V Battery Tester 100A Main Features
1.LED Digital meter can display voltage, current, capacity and time.
2.Keyboard will be used to setting protected voltage, discharge current ,capacity and time.
3.Automatically discharge when TIME OUT,EXCEED CAPACITY,or REACH PROTECTED VOLTAGE.
4.When the following conditions occur, the system will give alarm and cut off the load automatically: Overheat,
improper connection of positive and negative terminals, abnormal disconnection of battery pack.
5.The machine will automatically remember last parameter setting, for the same model of battery bank, it is not
necessary to reset again.
6.Cooling: Forced air cooling.
3.DC Dummy Load Discharger 24V Battery Tester 100A Specification
Model No. | DC24-100 |
Nominal Voltage | DC24V |
Discharge Voltage | 10-30V, DC24V±5% for MAX current (100A, long duration).Current reduces by Voltage decrease. |
Protected Voltage | 1-30V |
Discharge Current | 1-100A |
Discharge Time | 1M---99H59M |
Discharge Capacity | 1-9999Ah |
Accuracy | Current--0.1A, Voltage --0.1V |
Control Precision | ±(0.3%+0.2A) |
Working Power | AC 1-phase 110V/220V,50Hz/60Hz |
Cooling | Forced air cooling |
Work Environments | -10℃ ~ +40℃ (14℉~104℉) |
4.DC Dummy Load Discharger 24V Battery Tester 100A Product Display
(1)+; Red terminal block:power input terminal ( positive ), connect with the test cable and the device under tested
(positive).
(2)-; Black terminal block:power input terminal ( negative ), connect with the test cable and the device under tested
(negative).
(3)LED digital meter:Display parameters (voltage, current, time, capacity and so on).
(4)State indicator:Show the working condition of the current status.
(5)Operation keyboard:Set and Control parameters.
(6)Power Source Switch:Up is turn on.
(7)Power Source:Working power input terminal, put 3-wire AC 220V,50Hz working cable into this interface and
another end need to be connect to 1-phase 10V/220V,50Hz/60Hz power supply.
(8)Ground terminal, connect load bank and ground by using this terminal.
Parameter Setting Panel
DC Dummy Load Discharger Battery Tester Series Products
5.Company Show
AC Load Bank