Welcome to wziep.com!
category： Inverters & Converters
reference price：￥$45.70 - $72.70
RJ | M | - | 0R75G | - | S2 | |||||
Brand | Type | - | Power | Supply Power | ||||||
RIJING | M:Miniature | - | 0R4G ：0.4kw（0.5HP） 0R75G ：0.75kw（1HP） 1R5G ：1.5kw（2HP） | S1 ：Single 110VAC S2 ：Single 220VAC T4 ：Triple 380VAC | ||||||
Terminal label | Function description |
X0-X3 | Operation signal input |
V1 | Operation frequency input |
NC/NO/CM | Status output |
A+/B- | RS485 Communication RS485 |
L/N（R/S/T） | Input power |
U/V/W | Connecting motor |
〨 | Ground wire |
RJM-Product Series | ||
Maximal frequency | V / F control: 0: 400 Hz | |
Carrier frequency | 1.0kHz~16kHz | |
Input frequency resolution | Digital setting:0.01Hz | |
Simulation setting:maximal frequency×0.025% | ||
Control method | V/F control | |
Pull-in torque | G type machine:0.5Hz/150%(SVC) | |
Overload capacity | G type machine:150 % rated current 60s ; 180 % rated current 3s | |
Communication port | RS485 interface MODBUS-RTU communication protocol default 9600 baud rate | |
Input port | 4 external terminal input(X0-X3) | |
Output port | 1 relay output, 1 transistor output (DA output can be achieved) | |
External analog | 1 external analog input support 0-5 VX 4-20MA (jumper required) | |
Torque boost | Automatic torque lifting; manual torque lifting 0.1% | |
V / F curve | Three ways: linear type; multipoint type; N sub square V/F curve (1.2 power, 1.4 power, 1.6 power, 1.8 times, 2 times). | |
V / F separation | Two ways: total separation, semi-separation | |
Acceleration and deceleration curve | Linear acceleration and deceleration mode. Time range 0.0~6500.0s | |
DC injection braking | DC braking frequency:0.00Hz~ maximun-frequency braking time:0.0s~36.0s Braking current value:0.0%~100.0% | |
electronic control | Point frequency range: 0.00Hz~50.00Hz.~6500.0s | |
Simple PLC, multi-stage speed operation | Running at up to 16 segments by built-in PLC or control terminal | |
Built-in PLC | The closed loop control system of process control can be realized conveniently | |
Overpressure and overcurrent stall control | Automatic limitation of current and voltage during operation to prevent frequent overvoltage and tripping | |
Fast current limiting function | Minimize overcurrent failure and protect frequency converter from normal operation | |
Defencive function | Electrical motor short circuit detection, input and output phase deficiency protection, overcurrent protection, overvoltage protection, overheating protection, overload protection | |
LED display | Display parameter | |
Key locking and function selection | Implement partial or full locking of the keys and define the range of action of the partial keys to prevent misoperation | |
Place of use | Indoor, not exposed to direct sunlight, dust, corrosive gas, flammable gas, | |
Above sea level | Less than 1000m | |
Ambient temperature | -10℃+40℃(The ambient temperature is 40 ℃ ~ 50 ℃, please reduce the amount used) | |
Humidity | Less than 75 RH, no condensation of water droplets | |
Vibrate | Less than2.9m/s2(0.3g) | |
Storage temperature | -20℃~+60℃ | |
